Skip to content
Baby Point Door SpecialistsRequest a visit
Open 24/7(289) 804-5732Call now
Person in a jacket facing a closed white sectional door, with coiled springs and steel tubes on a wooden bench. — Extension Spring Replacement, Lambton Mills

Emergency Springs · Lambton Mills

Extension Spring Replacement in Lambton Mills

A bang like a dropped toolbox came from the garage last night. This morning one of the long springs beside the track hangs in two pieces, and the door will only rise a few inches before the opener gives up and stops.

Call now · open 24/7(289) 804-5732

Request a visit

Right now

Before the door is looked at

Call (289) 804-5732, open 24/7.

  1. When a spring breaks, the safe approach for the household is to leave the door where it is, keep people and vehicles clear, and avoid running the opener, which can damage the top section, the trolley or the gear drive.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

  3. Never drive a vehicle at a closed door to get out; the door collapses and the stored tension in the counterbalance is released. Use the release, the outside key release, or a technician.

In plain words

Extension springs are the two long coil springs that run beside the horizontal tracks of a garage door, one on each side. They stretch as the door closes and pull back as it opens, and that pull is what makes a heavy door feel light. Replacement puts a new, matched pair on the door. The technician opens and secures the door so the springs are slack, removes the old set, fits springs rated for the door's actual weight with containment cables through their centres, threads the lift cables over the pulleys, and adjusts both sides until the door balances. The opener is reconnected and tested last.

Sound familiar?

You pulled the red cord to open the door during a power cut and it barely moved. Lifting it took your whole weight, and when you let go it came down hard. It used to float up with one hand.

How the visit goes

Extension Spring Replacement · Lambton Mills

How the visit goes

Technician using a red drill at the curved upper track bracket beside a coiled spring above a white garage door. — Lambton Mills
  1. 1

    Securing the door with the springs slack

    An extension spring is stretched tight when the door is closed and nearly relaxed when the door is fully open, so the first move is to get the door up. The technician pulls the opener's release, raises the door by hand if it will go, and clamps both vertical tracks below the bottom rollers so the door cannot come down. If a broken spring has left the door stuck partway, it is lifted and supported with the weight taken on clamps and props before anything else is handled. With the door held open, the springs, pulleys and hooks can be examined and removed like ordinary hardware, which is the whole reason the sequence begins this way.

  2. 2

    Bringing the opener back into step

    The opener is the last thing touched. Once the door balances by hand, the trolley is reconnected and the door run through several full cycles under power while the technician watches the cables ride their pulleys and the springs stretch evenly. Because the door is now lighter to move than it was on tired springs, the opener's force and travel settings are reset to suit; a force setting left high would push a balanced door too hard. Then the reversal checks are done in front of you: a block laid flat under the centre of the door, which the door must touch and reverse from, and a hand passed through the photo-eye beam while the door closes.

  3. 3

    Knowing when the next set is due

    A standard extension spring is made for a set number of open-and-close cycles, commonly in the ten-thousand range, which on a door used four times a day works out to several years and on a door used twice a week to much longer. Springs age even when idle, as rust does its slow work in an unheated garage. The signs that the set is nearing the end are gradual: the door feels heavier by hand, the opener sounds as if it is working, the door drifts down from halfway, and gaps appear between coils when the door is open. Acting on those signs turns the next replacement into a planned appointment rather than a bang in the night.

In the van

  • Garage-door spray lubricant
  • Lag screws and hanger bolts
  • Containment (safety) cables
  • S-hooks and adjusting clips
  • Extension springs, matched pair

What affects the quote

  1. 1

    Door weight and size

    Spring rating follows the door's weight, and a wide insulated door or a wood door takes heavier springs than a light single. Weight and height together set the parts on the quote.

  2. 2

    Getting the van to the garage

    A detached garage down a shared laneway, a rural property or a building with the bay behind a gate takes more time to reach and set up in, and the quote allows for that.

  3. 3

    Time of the call

    An evening, weekend or holiday visit costs the same amount as a weekday daytime appointment for an extension-spring replacement. The technician confirms the exact figure once the springs, cables and door weight have been checked on site.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(289) 804-5732

Extension Spring Replacement: questions

Advice · (289) 804-5732

What is a safety cable, and does my door need one?

A safety or containment cable is threaded down the inside of each extension spring and fixed at the hanger behind and the bracket in front. It carries no load in normal use. If a spring snaps, the cable keeps the broken halves in place beside the track. Every extension-spring door should have one each side, and the industry's inspection checklist asks for it. Doors installed decades ago often have none; they are added with the new springs.

I added insulation and windows to the door. Does that affect the springs?

Yes, and it is one of the more common reasons a pair of springs is suddenly found wanting. Insulation panels, glazed sections, a wood overlay or a new steel skin all add weight the original springs were never chosen for, so the door grows heavy and the opener strains. When the springs are replaced, the door is weighed as it is now, and the new pair is rated for the door you actually have.

Can I use the door as soon as the work is done?

Yes. The last steps of the visit are the balance test by hand, several full cycles under power and the opener's reversal checks, so the door is ready for normal use when the technician leaves. New springs need no settling period. It is worth running it yourself once or twice while the technician is still there, so you know what a properly balanced door sounds and feels like from now on.

Toronto, Ontario

Lambton Mills information

Town
Lambton Mills, Toronto, Ontario
In business
12 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

58%

Older homes. About 58% of homes in Toronto were built in 1980 or earlier, according to the 2021 Census.

Where most houses were built a generation or more ago, a good share of garage doors are still the originals: wood or early steel sections on extension springs. Those doors respond well to fresh pulleys, safety cables and a careful balance, and the technician carries the parts for them.

23%

Single-detached houses make up about 23% of homes in Toronto (2021 Census).

Townhouses built in rows tend to have identical doors from the same builder, so when springs and openers age they do so together along the street. Owners often arrange service for several doors at once, and we can plan a single visit that covers the row.

Source: Statistics Canada, 2021 Census of Population

Open Lambton Mills in Google Maps

Open 24/7

Request a visit

A bang like a dropped toolbox came from the garage last night.

Call now · open 24/7(289) 804-5732
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 12 years in business